Econoline Paving Forms
In 2013 dee Concrete introduced our new line of Econoline light-duty (3/16") and heavy duty (1/4") paving forms for highway and runway (airport) applications.
dee's Econoline forms have been designed to be faster and less expensive to produce than standard paving forms. Econoline forms are available in either 3/16" or 1/4" thickness, with either a single or dual height pouring capability.
Typical Applications:
- Intersections
- Airport runways
- Truck pads
- Highway entrance/exit ramps
- Streets
- Roadways
- Heavy equipment pads
- Bridge approaches
- Commercial driveways
- Taper pours for ramps
 |
|
|---|---|
Full height sliding bull nose |
Fast alignment and easy stripping |
Full height 7-gauge steel welded stake pockets, single & double wedge |
Absolute form stability and concrete placement |
Fully welded 1/2" angle braces, and half end gussets on end connections |
Total form rail edge support Reduced screed hop |
Extra strength construction |
Greater load carrying capacity to support needed paving equipment |
Sliding nose that easily enters the reinforced box end from any angle |
Setup/ removal quick and easy |
Optional dowel holes |
Easy placement of dowels or rebar into forms requiring reinforced concrete |
Reinforced gussets and 7-gauge steel welded form pin pockets are among the strongest in the industry |
Provides many years, even decades, of useful life |
Optional reversible forms |
Increased flexibility: one set completes two separate placements |
Improved design |
Shortens production lead time by 1-2 weeks |
Economical to make |
Cost savings of approximately 25% vs. standard forms |
Same strength and qualityas standard forms |
no trade-off for lower cost |
Uses either 3/4" or 7/8" stakes |
No need for 1" pins |
